Watching Tv; Turning The Power On; Placing The System Into Standby - Pioneer PDP-5080XA Manual De Instrucciones

06

Watching TV

Chapter 6
Watching TV
Important
• Before watching broadcast channels, the built-in TV tuner must
be set up. See Setting up TV channels on page 24 for how to do
this.

Turning the power on

Press a on the plasma television when the POWER ON and
•
STANDBY indicators are off.
• The system is on.
• The POWER ON indicator lights up blue.
• Press a or 0 to 9 on the remote control unit or STANDBY/ON
on the plasma television if the STANDBY indicator lights red.
• The POWER ON indicator lights up blue.
• If you press 0 on the remote control unit, images from INPUT 1
will be displayed.
• If you press 1 to 9, TV images will be displayed.
20
En
All manuals and user guides at all-guides.com

Placing the system into standby

Press a on the remote control unit or STANDBY/ON on the
plasma television.
Plasma television status indicators
The table below shows the operational status of the plasma
television. You can check the current status of the system with the
indicators on the plasma television.
POWER ON
For other than the above, see Troubleshooting on page 56.
• The STANDBY indicator lights up red.
• The system enters the standby mode and the image on the
screen disappears.
Note
• When a on the plasma television is off, you cannot turn the
power on by pressing a or 0 to 9 on the remote control unit or
STANDBY/ON on the plasma television.
• When the system is placed into standby mode, the main power
flow is cut and the system is no longer fully operational. A
minute flow of power feeds the system to maintain operational
readiness.
• If you are not going to use the plasma television for a long period
of time, be sure to remove the power cord from the power outlet.
Indicator status
STANDBY
The power cord of the plasma
television has been disconnected. Or,
the power cord of the plasma
television has been connected but the
a button of the plasma television is
off.
Power to the system is on.
The system is in the standby mode.
Note
• You can select "High", "Mid" or "Low" for the brightness of the
POWER ON indicator (see Blue LED Dimmer on page 39).
System status