Signal Names For 15-Pin Mini D-Sub Connecter - Pioneer PDP-5080XA Manual De Instrucciones

13 Additional information
Problem
OTHER
• POWER ON indicator or
STANDBY indicator is quickly
flashing.
If the following error codes appear on the screen, check the corresponding items in the table.
Code Message
SD04 and SD11 Powering off. Internal temperature too high.
Check temperature around PDP.
SD05 (PDP-5080XA)
Internal protection circuit turns the system off.
Is there a short in speaker cable?
(PDP-4280XA)
Internal protection circuit turns the system off.

Signal names for 15-pin mini D-sub connecter

Pin No. Signal name
1 R
2 G
3 B
4 Not connected
5 Not connected
6 GND (ground)
7 GND (ground)
8 GND (ground)
58
En
All manuals and user guides at all-guides.com
Possible solution
• Internal protective circuits may have been activated. First turn off a on the plasma television, and
then turn the power on by pressing a again after waiting one minute or more. If the indicator is
still flashing, unplug the plasma television's power cord from the power outlet. Wait one to two
minutes then plug in the plasma television again. If this does not solve the problem, contact a
Pioneer Service Center. These are listed on your warranty card for each country. Alternatively,
check the Pioneer Web site (see cover) for contact details.
Check
Check if the ambient temperature of the plasma television is
high.
Check the speaker cable connections between the plasma
television and the speakers.
Contact a Pioneer Service Center. These are listed on your
warranty card for each country. Alternatively, check the
Pioneer Web site (see cover) for contact details.
Pin No. Signal name
9 +5 V
10 GND (ground)
11 Not connected
12 SDA
13 HD
14 VD
15 SCL