Installation Of Virtual Svv™ Drivers; Configuring Virtual Svv™ In Otoaccess - Interacoustics Virtual SVV Manual De Instrucciones

Virtual SVV™ Instructions for Use – US
Installation of Virtual SVV™ drivers
Connect the base station of the Virtual SVV™ to a USB port on the PC or laptop. The installation procedure
identifies whether the necessary driver software is already installed on the PC. If this is not the case, these
are installed automatically. If the necessary drivers are not installed on the PC, a Windows error message
will appear and a corresponding warning in the Device Manager is indicated. In order to install the drivers
manually, select the file FTDI-Setup.exe from the directory /FTDI Driver on the delivered installation media.
Select "Extract" to perform driver setup. Successful completion is notified by the message shown in the
figure below.
Configuring Virtual SVV™ in OtoAccess™
In order to setup Virtual SVV™ as an instrument within OtoAccess
appropriately. Open OtoAccess
Enter Virtual SVV™ in the "New Instrument Name" field. Select Virtual SVV™ in both the software and
hardware fields. Select "Create" to confirm Virtual SVV™ as a new instrument in OtoAccess
"Apply Settings" to keep changes. Select "OK" to exit setup.
NOTICE
Please note that OtoAccess
Instrument field.
TM
and select "File" and proceed to "Setup". Select the "Instruments" tab.
TM
must be restarted before the new instrument will appear in the Select
TM , the database must be configured
Page 11
TM
. Select