Operational Instructions; System Startup; Entering Patient Information - Interacoustics Virtual SVV Manual De Instrucciones

Virtual SVV™ Instructions for Use

4 Operational instructions

System startup

Enabling and disabling the Virtual SVV™ system
To enable the Virtual SVV™ system press the OK button on the handheld remote for approximately 2
seconds until the green ON LED indicator begins to blink, then release the button. The system initiates
after a further 3 seconds and the green ON LED ceases to blink and remains illuminated.
To disable the Virtual SVV™ system, press the two buttons  and  simultaneously for approximately
five seconds until the green ON LED extinguishes.
If the Virtual SVV™ system is not disabled manually, the handheld remote includes an internal timer that
is programmed to disable the system automatically after a predetermined interval. The standard factory-
set interval is 10 minutes. This interval can be set under the Preferences tab of the application software to
a value up to 30 minutes. The application software notifies the operator of automatic disabling of the
system with the following message box:
Figure 4-1 Message indicating automatic system disable after prolonged inactivity
The device can be re-enabled by pressing the OK button until the green ON LED lights up again.
NOTICE
To avoid total discharge and possible damage to the batteries the Virtual SVV™ device will also disable
automatically when the battery voltage reduces to a critical level. This condition is signaled to the operator
by the application software. If this occurs, the handheld remote must be recharged in the base station
cradle.
Once enabled, from the Windows
OtoAccess.

Entering patient information

From the Windows ® desktop, tap the OtoAccess
database will be populated with a list of all patients previously entered, which will be shown in the grid at
the bottom of the screen.
Select the New Client icon
the fields that are mandatory. These include the patient's first and last name, birth date, and person ID.
Enter the patient information and use the mouse or [Tab] key and [Shift] + [Tab] combination to move
between fields.
Tap the Save Client icon
®
desktop, click or touch the OtoAccess
TM database icon to launch OtoAccess.
to create a new client record. The fields marked with a red dot indicate
to save the information to the OtoAccess
TM
database icon to launch
The
TM
database.
Page 17