Hardware Setup; Attaching The Face Cushion To The Virtual Reality Goggle - Interacoustics Virtual SVV Manual De Instrucciones

Virtual SVV™ Instructions for Use – US Page 12

Hardware setup

The Virtual SVV™ system is composed of several components. Each component, its function and
installation is described below.
3.6.1

Attaching the face cushion to the virtual reality goggle

Step 1
Align the face cushion to the virtual reality goggle, with the side with black fabric towards the virtual reality
goggle. To facilitate this, fold the face cushion slightly, as shown in Figure 3-6. Center it against the
virtual reality goggle. The face cushion should be positioned so that the upper section of the cutaway is
aligned with the upper edge of the viewing aperture of the virtual reality goggle as illustrated below.
Ensure that the face cushion does not occlude the viewing aperture of the virtual reality goggle.
Figure 3-6 Aligning the face cushion to the virtual reality goggle
Step 2
The lower section of the face cushion is intended to fit snugly around the nose. This section should be
aligned with the lower edge of the viewing aperture as shown in Figure 3-7. When correctly aligned, the
face cushion can be pressed firmly to adhere to the virtual reality goggle.
Figure 3-7 Fastening the face cushion
Step 3