Mounting Orientation - Aventics CL03 Instrucciones De Servicio

AVENTICS | CL03, CL03-XL | R402000141–BAL–001–AF
Risk of injury or damage due to uncontrolled movement
of system components!
Connection of compressed air while the valve system is being
installed may lead to physical injury or system damage.
Make sure that the relevant part of the system is not
under pressure during installation.
Make sure that the valve system is completely installed
before connecting compressed air.
If the system has to be left unattended during
installation, make sure that the compressed air supply
cannot be reconnected.
Uncontrolled movements of incorrectly connected
compressed air lines in the valve system!
Incorrectly assembled compressed air lines with plug
connections could come loose when pressure is applied
to the valve system, resulting in injuries or damage
to the device.
Always check that the plug connections are effective
by gently pulling on the inserted line.
5.1

Mounting orientation

The valve system may be mounted in any orientation. However,
observe the following points:
The system must not be installed with the connection side
pointing upwards to prevent condensate from flowing into
the valve.
In order to optimally protect the pilot valves from
contaminated compressed air, they must not be located
on the underside.
WARNING
WARNING
65
Assembly