Aventics CL03 Instrucciones De Servicio página 61

AVENTICS | CL03, CL03-XL | R402000141–BAL–001–AF 59
For Your Safety
Always make sure the relevant system component
is not under pressure or voltage before carrying out work
on the valve system. Ensure the system cannot be switched
on accidentally during work.
This device may only be used for industrial applications
(class A).
On installation The warranty only applies to the delivered configuration.
The warranty will not apply if the product is incorrectly
assembled.
Make sure the valve system is grounded for versions with
bus coupler.
During commissioning Make sure that attached system components are properly
secured.
Do not put the system into operation before it is completely
assembled as well as correctly wired and configured,
and after it has been properly tested.
Before commissioning, make sure that all the connection
seals and plugs are leaktight to prevent fluids or foreign
bodies from penetrating the device.
During operation In certain applications there may be a risk of crush injuries.
Always follow the safety instructions specific
to the application.
Make sure that there is a sufficient exchange of air
or enough cooling if any of the following applies:
– Fully equipped system
– Continuously loaded solenoid valves
Maintenance Only use solvents or detergents in low concentration
in accordance with the respective product regulations
and for short periods of exposure.
Always comply with the conditions of protection class IP69K.
Waste disposal Dispose of the device in accordance with the currently
applicable regulations in your country.