Setting The Internal And External Pilot Air - Aventics CL03 Instrucciones De Servicio

AVENTICS | CL03, CL03-XL | R402000141–BAL–001–AF
24
Fig. 15: Inserting blanking plugs to obtain separate pressure zones.
3. Reassemble the valve system according to the instructions
in section "Assembling the valve system on the mounting
surface" on page 66.
8.4

Setting the internal and external pilot air

The valve system can be supplied internally or externally with
pilot air depending on the configuration. This feature can
be subsequently changed by positioning the seal on the end
plate accordingly.
Valve systems that have an end plate with additional
connections 3 and 5 can only be supplied externally
with pilot air. If you would like to change the valve system
to internal supply, the end plate must be exchanged.
Conversion and Extension
93