Removing The End Plate; Installing Subbases - Aventics CL03 Instrucciones De Servicio

88 AVENTICS | CL03, CL03-XL | R402000141–BAL–001–AF
Conversion and Extension

8.2.3 Removing the end plate

Fig. 11: Removing the end plate
1. Remove the end plate (4) by undoing the three hexagon
screws (20) using an 8 mm wrench.

8.2.4 Installing subbases

In order to install subbases, the corresponding number
of tie rod extensions, consisting of three tie rods and three
tie rod nuts, are required depending on the number
of valves. Tie rod extensions for valve systems CL03
and CL03-XL can be found in the online catalog
(www.aventics.com/pneumatics-catalog).
4
20