ABB Sensyflow FMT500-IG Manual De Instrucciones página 92

Commissioning
Parameterization (password-protected)
Local parameterization via display using magnetic pen (see Section 8, "Operation") or
Parameterization via DTM in FDT 1.2 frame applications (e.g., ASSET VISION).
Once a period of two minutes has elapsed following successful configuration or since the last
entry was made, the device automatically switches to the default display screen and reverts to
the STANDARD operation mode.
Configuration of the PROFIBUS slave address
-
-
PROFIBUS DP configuration of cyclic data exchange with the class 1 master process
control system
-
Parameterization and configuration
-
-
Once a period of two minutes has elapsed following successful configuration or since the last
entry was made, the device automatically switches to the default display screen and reverts to
the STANDARD operation mode.
IMPORTANT (NOTE)
On the various display screens, the -II- connect symbol indicates whether there is an active
PROFIBUS connection to the class 1 / class 2 master. If there is no connection, -I I- is
displayed instead.
In the event of an error, the error symbol "E" appears (see Section 8, "Operation").
38 - EN
92
Set locally on the display in SPECIALIST / SERVICE mode
or
By the class 1 master process control system or class 2 master parameterization and
configuration tool using the SET-SLAVE address telegram.
Read the GSD file supplied into the control system and save it in the relevant subdirectory.
Local parameterization via display using magnetic pen
or
Parameterization and configuration via DTM in FDT 1.2 frame applications
(e.g., ASSET VISION).
Sensyflow FMT500-IG CI/FMT500-IG-X1