Cleaning And Maintenance; Defects And Malfunctions; Transport And Storage; Additional Information - Tunturi E80 Manual Del Usuario

Press the jog wheel button or back button to leave this
page ,and Bluetooth Module will be turned off.
‼ NOTE
• Tunturi only provides the option to connect
your fintess console throughout a bluetooth
connection. Therefore Tunturi cannot be held
resposible for damage, or malfunctioning of
products other than Tunturi products.
• Check the website for extra information.
www.Tunturi.com

Cleaning and maintenance

The equipment does not require special maintenance.
The equipment does not require recalibration when
it is assembled, used and serviced according to the
instructions.
⚠ WARNING
• Do not use solvents to clean the equipment.
- Clean the equipment with a soft, absorbent cloth
after each use.
- Regularly check that all screws and nuts
are tight.
- If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and
malfunctions caused by individual parts can occur in the
equipment. In most cases, it will be sufficient to replace
the defective part.
- If the equipment does not function properly,
immediately contact the dealer.
- Provide the model number and the serial number of
the equipment to the dealer. State the nature of the
problem, conditions of use and purchase date.
Trouble shooting:
- When the display of LCD is dim, it means the
batteries need to be changed.
- If there is no signal when you pedal, please check if
the cable is well connected.
‼ NOTE
• When stop training for 4 minutes, the main
screen will be off.
• If the computer displays abnormally, please re-
install the batteries and try again.
Squeaking rollers
- Regular Usage: Apply 2cc. of the lubricant on each
protruding rail surface every three months.
- When sliding wheels are making noise during
sliding movement, apply 2cc. of lubricant on each
protruding rail surface immediately.
⚠ CAUTION
• We recommend to use a silicon based lubricant.
• Do not apply too much lubricant or wipe off
redundant lubricant with a clean cloth as too
much lubricant can cause carpet stain or dirt
particle.
Shaky or unstable feeling during use
If the machine feels unstable or unstable during
operation, it is advisable to adjust the support feet
to bring the frame to the correct height. Read the
instructions in this manual in section: "Use"

Transport and storage

⚠ WARNING
• Carry and move the equipment with at least two
persons.
- Remain standing in front of the equipment on each
side and take a sturdy grip at the handlebars. Tilt
the front of the equipment so as to lift the rear of
the equipment on the wheels. Move the equipment
and carefully put the equipment down. Place the
equipment on a protective base to prevent damage
to the floor surface.
- Move the equipment carefully over uneven surfaces.
Do not move the equipment upstairs using the
wheels, but carry the equipment by the handlebars.
- Store the equipment in a dry place with as little
temperature variation as possible.

Additional information

Packaging disposal
Government guidelines ask that we reduce the amount
of waste material disposed of in land fill sites. We
therefore ask that you dispose of all packaging waste
responsibly at public recycling centres.
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable
use from your fitness trainer. However, a time will come
when your fitness trainer will come to the end of its
useful life. Under 'European WEEE Legislation you are
responsible for the appropriate disposal of your fitness
trainer to a recognised public collection facility.
2 9
English