Tabla De Contenido - Franklin Electric 6 Serie Manual De Instrucciones

GB
Franklin Electric Europa GmbH
Rudolf-Diesel-Straße 20
D-54616 Wittlich, Germany
Tel.:+49 (0) 65 71 / 105 - 0
Fax: +49 (0) 65 71 / 105 - 520
E-Mail: service-de@franklinwater.eu
Internet: www.franklinwater.eu
Doc.-Nb.: 308 018 418
Version: Rev.18; July 2020
© Copyright by Franklin Electric Europa GmbH 2005
All rights in these instructions are reserved - specifically the copying, distribution and translation rights. No part of these
instructions shall be reproduced, or processed, copied or distributed using electronic systems or otherwise without the prior
permission in writing of Franklin Electric Europa GmbH.
Changes due to technical developments reserved.
Encapsulated
Submersible Motors,
6" and 8"
Assembly and operating
instructions
1 With this document ....................................................... 2
1.1 Warning notices and warning symbols ............................ 2
1.2 Instructions and highlights ............................................... 2
2 Safety .............................................................................. 3
2.1 Intended use .................................................................... 3
2.2 Target group .................................................................... 3
2.3 General safety instructions .............................................. 3
3 Storage, transport, disposal ......................................... 4
4 Technical specifications ............................................ 4/5
5 Putting the motor into use ............................................ 6
5.1 Checking the motor prior to installing it ......................... 6/7
5.2 Motor and pump assembly .............................................. 7
5.3 Motor cable ................................................................... 7/8
5.4 Measuring the insulation resistance ............................. 8/9
5.5 Making the electrical motor connection ...................... 9/10
6 Motor operation ........................................................... 11
6.1 Making sure that the motor is cooled sufficiently ...... 11/11
6.2 Providing a check valve and a level sensor ................... 11
6.3 Switching on the motor .................................................. 11
6.4 Operating a motor with a frequency converter ............... 11
6.5 Operating a motor with a soft starter ............................. 12
7 Maintenance and service ............................................ 12
8 Troubleshooting .......................................................... 12
9 Service .......................................................................... 12
10 Appendix ...................................................................... 12
1