SICE S 200 Manual De Instrucciones página 106

8. Then lock the pin using the M6 screw supplied.
9. After removing the cap, connect the lifting device to the
supply by connecting the T6 hose to the multiple distributor
inside the machine, using one of the free outputs.
Connect the lifter to the control pedal using the previously
connected T4 hose. Activate the control valve by pressing
fully down the slider located in the top part of the valve.
10. Then close the left side panel of the tyre changer and
reconnect the tyre changer to its supply sources. Check that
device is operating correctly as follows:
- press the lifting device drive pedal down once: the platform
rises and remains in position;
- press the lifting device drive pedal down again: the
platform moves down to the ground and remains in position.
Before restoring the pneumatic supply, follow the indications in "Electrical and
pneumatic connections".
106
WARNING
Manuale d'uso S 200