Maintenance; Hot Swapping The Power Sub-Module; Disconnecting The Power Sub-Module; Reconnecting The Power Sub-Module - Eaton Pulsar Serie Manual De Instalacion Y Uso

Hot swapping the power sub-module

This operation must be carried out by qualified electrical personnel only.
This operation can be performed without interrupting the equipments.

Disconnecting the power sub-module :

Reconnecting the power sub-module :

Carry out the above instructions in reverse order.
Replace the faulty power sub-module by another one with same power rating.

Hot swapping the battery sub-module

Caution: a battery can cause electrocution and high short circuit currents.
Do not dispose of batteries in a fire. The battery may explode
Do no open or mutilate batteries. Released electrolyte is harmful to the skin and eyes. It may be toxic.
Servicing of batteries should be performed or supervised by personel knowledgeable of batteries and the required
precautions. Keep unauthorized personel away from batteries.
Remove watches, rings, bracelets and all other metal objects from the hands and arms,
Use tools with an insulated handle.
When replacing batteries, replace with the same number of the BB/HR5.5-12 batteries.
This operation can be performed without interrupting the equipments.

Disconnecting the battery sub-module :

Reconnecting the battery sub-module :

Carry out the above instructions in reverse order.
To ensure safety and high performance, use only batteries supplied by EATON.

7. Maintenance

1 - Remove the 6 fixing screws to free the
main front panel bezel.
2 - Remove the 4 fixing screws on the left
side to free the power sub-module.
3 - Withdraw the power sub-module.
1 - Remove the 6 fixing screws to free the
main front panel bezel.
2 - Remove the 4 fixing screws on the right
side to free the battery sub-module.
3 - Pull the battery sub-module slightly,
then lift it to extract it.
34008486EN/AC - Page 39