Single Phase Input; Common Sources; Separate Sources - Eaton Pulsar Serie Manual De Instalacion Y Uso

2. Installation

Single phase input

This type of connection must be carried out by qualified electrical personnel

Common sources

Separate sources

-
34008486EN/AC Page 24
1
1 - Be sure that the one-phase metal strap
is installed
2
2 - Be sure that the metal jumper is
installed
3 4
3 - Connect the 3 cables to the normal AC
source terminal block
4 - Connect the 3 cables to the output
terminal block
5 - Be sure that input selection selector (1)
1
is set to single phase position.
1 - Be sure that the one-phase metal strap
is installed
2 - Connect the 3 cables to the normal AC
terminal block
1 2 3
3 - Connect the 3 cables to the output
terminal block
4 - Be sure that single phase or three-
1
phase switch selection (1) is set to single
phase position.