Three Phases Input; Common Sources; Separate Sources - Eaton Pulsar Serie Manual De Instalacion Y Uso

Three phases input

This type of connection must be carried out by qualified electrical personnel

Common sources

Separate sources

1
2
2
3
3
1
2
1 2
3
2. Installation
1 - Remove the one-phase metal strap (1)
2 - Be sure that the metal jumper (2) is
installed
3 - Connect the 5 cables to the normal AC
source terminal block
4 - Connect the 3 cables to the output
terminal block
4
5 - Remove cover and put input selection
selector (3) to three phase position.
1 - Remove the one-phase metal strap (1)
2 - Remove the metal jumper (2)
3 - Connect the 5 cables to the normal AC
source terminal block
4 - Connect the 3 cables to the bypass AC
source terminal block
3
5 - Connect the 3 cables to the output
terminal block
5 - Remove cover and put single phase or
three-phase switch selection (3) to three-
phase position.
34008486EN/AC - Page 25