Checking And Replacing The Wear Guard; Maintenance And Care - Stihl FCS-KM Manual De Instrucciones

English
Checking and Replacing the
Wear Guard
Checking the Wear Guard
1
2
Check the wear guard (1) for
N
damage before starting the power
tool.
The wear guard must be replaced
N
as soon as the gearbox (2) (arrow)
becomes visible.
NOTICE
The gearbox may be seriously damaged
if you do not replace the wear guard in
good time.
18
Replacing the Wear Guard
4
5
Remove the cutting blade - see
N
"Mounting the Cutting Blade".
Remove the thrust plate (3).
N
Take out the screws (4).
N
Fit the new wear guard (5).
N
Insert the screws (4) and tighten
N
them down firmly.
Fit the thrust plate (3).
N
Mount the cutting blade - see
N
"Mounting the Cutting Blade".

Maintenance and Care

The following intervals apply to normal
operating conditions only. If your daily
working time is longer or operating
conditions are difficult (very dusty work
area, etc.), shorten the specified
intervals accordingly.
4
Accessible screws and nuts (not
wingnut for depth wheel)
Check and retighten if necessary
N
Depth wheel
Visual inspection before starting
N
work
Check tightness of wingnut before
N
starting work
Have replaced if necessary – see
N
"Replacing Wheels"
Skirt
Visual inspection before starting
N
work
Replace if damaged – see
N
"Replacing the Skirt"
Blade
Visual inspection before starting
N
work
Check tightness before starting
N
work
Have checked for out-of-balance if
N
necessary, replace if out-of-balance
– see "Replacing the Cutting Blade"
Replace if damaged – see
N
"Replacing the Cutting Blade"
FCS