Setting Front Panel Orientation; Attaching The Enclosure To The Brackets - Mettler Toledo IND780 Guia De Instalacion

2.3.2.3.

Setting Front Panel Orientation

Establish whether the terminal will be mounted above or below eye level. If it will be mounted at or
below eye level, the orientation of the front panel must be reversed. Follow these steps:
1. Open the enclosure as described in the Opening the Enclosures section.
2. Loosen and remove the two nuts securing the two metal cables (Figure 2-7) that hinge the front
3. Carefully rotate the front cover 180 degrees and reattach the two grounding straps to the two
2.3.3.

Attaching the Enclosure to the Brackets

Once the brackets are securely fastened to the wall surface, the enclosure can be mounted to them
using the four supplied M5 screws. One bracket is shown in Figure 2-9, with the slotted holes
indicated. The screws are tightened by fitting the screwdriver through the slotted holes.
Figure 2-10 shows the brackets attached to an enclosure. Note the orientation of the enclosure
relative to the brackets.
64057253 | 14 | 08/2014
cover to the rear housing.
Figure 2-7: Ground Strap Attachment Locations
studs near the grip bushings using the two nuts removed in the previous step. Figure 2-8
shows one of the studs. Tighten the two nuts.
Figure 2-8: Stud for Attaching Reversed Front Panel
Terminal Mounting Holes
Slotted Wall-Mounting Holes
Figure 2-9: Wall-Mounting Bracket
METTLER TOLEDO IND780 Installation Guide
Stud
2-7