Requirements; Intended Use; Warranty - Eaton xChargeIn Serie Manual De Instalación

xChargeIn
1.3

Requirements

This document contains information for persons with the following require-
ments:
Electrician
1.4

Intended use

The charging station is intended for charging electric vehicles (such as elec-
tric cars). The connection of other devices (such as power tools) is not al-
lowed.
The charging station is suitable for indoor and outdoor use. The charging
station has to be installed vertically on a wall or on a floor-mounted column.
The surface for the installation must be flat and suitably stable (e.g. brick
wall, concrete wall). The respective national regulations must be observed
with regard to the installation and connection of the charging station.
The intended use of the device always includes the compliance with the en-
vironmental conditions for which this device was developed.
The charging station has been developed, manufactured, tested and docu-
mented in accordance with the appropriate safety standards. If the instruc-
tions and safety instructions described for the intended use are observed,
the product will normally not pose a risk to the health of persons or damage
to property.
Not observing the safety instructions can result in risk of death, in-
juries and damage to the device!
The device manufacturer assumes no liability for resulting claims!
1.5

Warranty

Only general maintenance work that is expressly permitted by Eaton may be
performed. Any other tampering to the device will result in a loss of the war-
ranty claim.
Installation manual V1.05
© EATON
Target group
Person who, due to his or her special training, expertise and experi-
ence as well as knowledge of current standards, is able to assess
the work performed and the possible hazards.
Knowledge of:
●
●
●
●
●
●
●
Required knowledge and abilities
current valid safety information,
the mode of operation of the charging station,
the displays and operating elements of the charging station,
basics of network technology,
diagnostic options,
systematic fault analysis and rectification,
the setting options on the charging station.
Introduction
261