Notes On This Document - Eaton xChargeIn Serie Manual De Instalación

Introduction
WARNING!
Risk of electric shock and fire hazard!
After the front part has been opened, product safety can no longer be guar-
anteed.
Only those covers that are described in the procedure instructions are al-
lowed to be opened. If one of the covers is sealed by a lead seal, it is not
permitted to be opened by unauthorized persons. If the lead seal is broken,
the device loses its specific suitability for use and may no longer be put into
operation due to the resulting incorrect identifier.
Fig. 1-1: Screws on the front part
The front part
will break the manufacturer's seal and void the warranty claim. For a war-
ranty claim, there is a duty of proof of the customer that the defect – which
led to the defect of the device – already existed at the time of delivery. If the
manufacturer's seal is broken, this proof can no longer be provided, resulting
in expiration of the warranty claim.
A device with broken manufacturer's seals or removed lead seals may no
longer be put into operation. The necessary steps for replacement of the
charging station by the specialist dealer or service partner must be initiated.
1.6

Notes on this document

The manual is part of the product. It is to be retained over the entire life cycle
of the product and should be forwarded to any subsequent owners or users
of the product.
262
1 must not be opened. Opening the front part (4 Torx screws)
xChargeIn
Installation manual V1.05
© EATON