Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 75

Lay the Perimeter Wire from the Perimeter Switch to the
lawn.
Start laying the wire in anticlockwise direction.
•
Once completing the Perimeter Wire loop, lay the wire
•
back towards the Perimeter Switch.
At the end of the Perimeter Wire loop, you have now two
•
wires. Lay the two loose wires in the direction of the
Perimeter Switch location and peg them to the ground
using a single peg for both.
4.8.4. At the Perimeter Switch's location:
Trim the ends of the loose wire to equal length and twist
•
them together.
Strip 5mm (0.2 inches) of insulation from the wire without
•
the plot connector.
Insert this wire end into the free hole in the connector and tighten
•
the screws.
Plug the perimeter wire connector into the Perimeter Switch.
•
2 wires under
the same peg.
Small flat screwdriver