Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 87

Screen Setting
Automatic
Operation
¤ ¥ § ¦
(Default =
 
Add Sub-Zone
¤ ¥ § §
Update Distance
¤ ¥ § © To Sub-Zone
SmartMow
¤ ¥ § 
(Default =
  
SmartMow
Edge Overlap
¤ ¥ § 
(Default =
¦ ¥
• This menu enables or disables (pauses) Automatic Operation
either in the main zone ('L1'), one of the Sub-Zones ('A1/ A2/ A3/
A4') or in the entire lawn ('All').
• When setting Automatic Operation to Off in a particular zone, the
)
mower will skip the operation in that zone, but will continue to
mow all the other zones.
• Enables the addition of a Sub-Zone. Maximal number of Sub-
Zones may be different for each the unit model.
• A1/A2/A3/A4 (name of the first available sub-zone) is displayed -
press OK.
• If the mower is not at the Base Station, then 'U044' ("Place the
mower in the Base Station") is displayed. Place the mower in the
Base Station and press OK.
• The mower will start moving towards the Sub-Zone. 'U041' ("
the STOP button at Sub-Zone entry.
• Press 'STOP' button, when the mower is at any point beyond the
Narrow Pass and inside the Sub-Zone (Entry Point).
• Scroll to set the area of the Sub-Zone and press OK.
• Note! This process is not a part of the One-Time Setup (see
Section 5.2)
• The area setting of a Sub-Zone can be later updated through the
'Area' menu of the Basic Settings (see Section 6.4.1)
• The distance to Sub-Zone's entry point can later be update
through menu P023
• This menu is shown only if a Sub-Zone has been defined.
• It allows updating the distance to Sub-Zone's entry point.
• Scroll to choose the required Sub-Zone (A1/A2/A3/A4) and press
OK to update the distance to the entry point.
• Enables the unique SmartMow feature.
• SmartMow feature allows more efficient mowing operation
through the smooth and continuous turns when reaching lawn's
edge.
• This feature may not be efficient in the same way in every lawn or
in some parts of a particular lawn.
• When this feature is enabled for the first time in a particular zone,
)
it may require the mower to cross the lawn and "touch" the
perimeter wire several times (to perform an initial calibration of
the algorithm), before it will start performing smooth turns at
lawn's edge.
• If there is more than one zone defined, then there is an option to
enable this feature for a particular zone or for the entire lawn
('all').
• Allows adjusting the degree of overlapping with lawn's edge,
when performing the smooth and continuous turns in SmartMow
mode.
• Increasing this value will cause a higher overlapping with lawn's
edge (for better mowing results), but at some point may prevent
)
the mower from performing a smooth turn.
• If there is more than one zone defined, this setting may be set per
zone or for the entire lawn ('all').
Description
") will be displayed.
Options
" # #
! ¦
" ¦ ¨ " § ¨ " © ¨ " 
  ¨   
Press
" ¦ ¨ " § ¨ " © ¨ " 
¦ ¥ ¥
" # #
! ¦ ¨ ! § ¨ ! ©
" ¦ ¨ " § ¨ " © ¨ " 
  ¨   
  © ¥