Wolf Garten Robo Scooter 300 Instrucciones De Funcionamiento página 93

Start Inside
8 8 E 8
Stuck in place
8 8 E 9
Check mowing
8 8 D 8
hours (%)
Decrease
8 8 D 9
Inactive Time
9.3. User Messages
The next table gives information about User Messages that can be displayed on the mower:
Display
Recharge Battery. Low battery voltage.
H I P P
Test Base Station position.
Q 8 8 9 Displayed during the One-Time Setup.
Peg Base Station.
Q 8 8 A Displayed during the One-Time Setup.
Test wire position.
Q 8 8 E
Displayed during the One-Time Setup.
Wire Test ended (during the One-Time Setup)
Q 8 8 B Displayed only when using Robomow® App.
Operation time is completed as expected.
Q 8 9 F
Operation time is shorter than expected
Q 8 9 G
Keep charging if not used.
Displayed only if the mower is disconnected from a
Q 8 A B
Charging Adaptor.
Switch Off before lifting
Q 8 A C
Change the wires in plot connector
Q 8 A R Displayed during the One-Time Setup.
Switch on the System Switch.
Displayed if the mower is connected to charging, but
Q 8 E A
the System Switch is 'Off'.
Press the STOP button at Sub-Zone entry.
Q 8 B 9 Unit
Learning edge distance.
Q 8 B A
Going to Sub-Zone entry point. Displayed when the
Q 8 B E mower drives towards the Sub- Zone
Place the mower in the Base Station.
Q 8 B B
Reposition the Base Station position.
Q 8 C 9 Displayed during the One-Time Setup.
Adjust Wire
Q 8 C A
An alarm will soon be activated.
Q 8 D A
The Searching Base Station operation cannot be
Q 8 D B performed
Automatic operation is initiated while the
@
robot is placed out of the Perimeter Wire loop.
See E1 in the above table
@
The mowing hour's % value you have set is too
@
high for your lawn area.
See E8 in the above table
@
Message / Description
Place the mower inside the lawn and renew the
@
operation.
Decrease the mowing hours % you have set for the
@
zone(s) in your lawn.
Required Action
Recharge the Battery.
Refer to section 5.2.4 in the User Manual.
Refer to section 5.2.4 in the User Manual.
Refer to section 5.2.5 in the User Manual
No action is required.
No action is required.
Battery run time is too short. Replace Battery.
It is recommended to keep the mower connected to the
Power Supply when not in use.
It is required to switch Off the System Switch before lifting
and carrying the mower.
Swap the wires at the plot connector.
Refer to section 5.2.4 in the User Manual.
Switch the System Switch to 'On'.
Press STOP at the point you want the mower to start
mowing the Sub-Zone.
The mower learns the distance of the Perimeter Wire in a
Separated Zone. Press STOP to learn the distance.
No action is required.
Place the mower in the Base Station before starting the
process of adding a Sub-Zone.
Refer to section 5.2.4 in the User Manual.
Refer to section 5.2.5 in the User Manual.
This message warns you to enter the PIN code before the
Anti-Theft alarm will sound.
When choosing the 'Home' button in a zone without a Base
Station.