Inside The Transmitter; More About The Hardware; Transmitter Aerial / Storage Compartment; Multi-Function Socket With Sliding Cover - Multiplex Cockpit SX Manual De Instrucciones

9.4.

Inside the transmitter

a.
b.
Fig. 9.4.: The interior of the transmitter
(Channel-Check PLUS installed)
1. Adjustor screws, right-hand stick unit
a. Centring spring tension, right / left
b. Centring spring tension, forward / back
2. Transmitter battery connector
3. Transmitter battery
4. Adjustor screws, left-hand stick unit
a. Centring spring tension, forward / back
b. Centring spring tension, right / left
5. Contacts for optional Channel-Check PLUS
9.5.

More about the hardware

9.5.1.

Transmitter aerial / storage compartment

The stainless steel telescopic aerial of the C
is 1.40 m long. It must be screwed into the transmitter
socket before the unit is switched on.
To remove the aerial from its compartment press the
release button at the bottom of the transmitter.
To store the aerial, slide it into the hole in the left-hand
side of the case. Press the release knob when fitting
the aerial; when fully inserted the aerial snaps into
place, and cannot fall out again.
Release knob TORX key
Fig. 9.5.1.:
9.5.2.
The multi-function socket of the C
the following purposes:
• Charging / discharging the transmitter battery (max.
1.5 A)
• Connecting the Trainer lead
• Connecting the Diagnosis lead
(cable connection to the receiver)
a.
• PC interface
b.
(e.g. for operating a flight simulator)
The socket is fitted with a sliding latch to protect it from
dirt and damp.
Sliding cover
Multi-function
socket
Knob for
sliding cover
Fig. 9.5.2.: Multi-function socket with sliding cover
9.5.3.
The two sliders of the C
from above or the side. This makes the transmitter
ideal for use as a hand-held unit or in a transmitter tray.
SX
OCKPIT
from the side
Fig. 9.5.3.: Operating the sliders
9.5.4.
The transmitter case must be opened in order to re-
place the transmitter battery (7 screws,
Note: no data loss when the battery is replaced!
The model data in the C
volatile memory. Even if the battery is disconnected for
a long period, the data is retained.
! Use only genuine MULTIPLEX transmitter batter-
ies with an integral fuse
Aerial
Page 13
Operating Instructions

Multi-function socket with sliding cover

OCKPIT

Operating the sliders from above / the side

SX can be operated
OCKPIT
from above

Replacing the transmitter battery

SX is stored in non-
OCKPIT
SX is used for
in Fig. 9.3.).