Ash Removal; Service - Jøtul F 262 Instrucciones Para Instalación

ENGLISH
Adding firewood
Stoke the stove frequently but only add small amounts of fuel at
a time. If the stove is filled too full, the heat created may cause
extreme stress in the chimney. Add fuel to the fire in moderation.
Avoid smouldering fires as this produces the most pollution.
The fire is best when it is burning well and the smoke from the
chimney is almost invisible.
5.2 Danger of overheating
The fireplace must never be used in a manner that
causes overheating
Overheating occurs when there is too much fuel and/or too much
air so that too much heat develops. A sure sign of overheating is
when parts of the fireplace glow red. If this happens, reduce the
air vent opening immediately.
Seek professional advice if you suspect that the chimney is not
drawing properly (too much/too little draught). For further
information, see «4.0 Installation» (Chimney and flue pipe).

5.3 Ash removal

The product have an ash pan which makes it easy to remove
the ash.
Use the fireplace set (Fig. 24).
Warning: The fireplace set can get hot.
Fig. 27
A
12
1. Scrape the ash through the grate (Fig. 27 A) in the base plate
and into the ash pan. Use a glove to grab the handle on the
ash pan.
2. Make sure that the ash pan doesn't fill up so high that it keeps
ash from coming through the grate into the pan.

6.0 Service

Warning! Any unauthorised change to the product is not allowed.
Only use original spare parts.
All service must be done when the stove is cold!
6.1 Changing the burn plates/inner
bottom plate
Fig.28
B
D
A
C