Maintenance; Cleaning And Soot Removal - Jøtul F 262 Instrucciones Para Instalación

ENGLISH
Fig. 32
A
Remove the screw (fig. 32 A) on the inside of the base.
1.
Fig. 33
1. Pull the side panel out (fig. 33 A).
2. Tilt the side panel gently to the front.
3. Lift the side panel up.
4. Replace glass and gasket.
For re-installation follow the same procedure in the opposite
sequence.
14
2
1
3
A
6.5 Re-installation of the base door
Fig. 34
Fig. 35
If adjusting is needed - see figure 29.

7.0 Maintenance

All maintenance must be done when the stove is cold!

7.1 Cleaning and soot removal

Soot deposits may build up on the internal surfaces of the
fireplace during use. Soot is a good insulator and will therefore
reduce the fireplace's heat output. If soot deposits accumulate
when using the product, they can easily be removed by using a
soot remover.
In order to prevent a water and tar layer from forming in the
fireplace, you should regularly allow the fire to burn hot in order
to remove the layer. An annual internal cleaning is necessary to
get the best heating effect from your product. It is a good idea
to do this when cleaning the chimney and flue pipes.
7.2 Sweeping flue pipes to the chimney
Flue pipes must be swept through the flue pipe sweeping hatch
or through the door opening.
One of the baffles will have to be removed first in order to do this.