Tool Holder - Fein FSC1.6X Manual De Instrucciones

3 41 01 120 21 0.book Seite 16 Dienstag, 10. März 2009 10:19 10
en
Firmly press in the fastening element to
the stop. Then lock the rapid-clamping
lever.
Loosen the clamping lever and
swivel it to the stop.
Pull out the fastening element.
Clean the tool holder, the applica-
tion tool and the fastening element.
Place the application tool exactly
onto the star-shaped tool holder. Pay
attention that the application tool has a
flush fit.
Insert the fastening element to the
stop into the tool holder.
Swivel the clamping lever back until
it engages.
Clamp cutting blades for the vehicles sector as shown in (Figure. 8).
Before mounting or replacing
WARNING
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the
power tool.
For all work or when chang-
CAUTION
ing application tools, always
wear protective gloves. Danger of injury
from the sharp edges of the application
tools. Application tools can become very
hot while working. Danger of burns!
The cutting blades marked with a symbol
(Fig. 8) may only be operated as indicated.
A Cutting blade, straight and curved.
B Cutting blade, bent at right angles.
C Cutting blade, U-form.
D Cutting blade, L-form.
E Scraping knife.
F Scraping knife.
G Cutting blade with stop roller.
16
FSC1.6X/FSC1.6Q/FSC2.0Q
Fig. 7
Cover
180°
Clamping
lever
The cutting blades marked with a symbol
(Fig. 8) may only be operated as indicated.
Guide the straight, bent or off-set cutting
blades at a right-angle to the window flange.
For U-form cutting blades, pay attention
that the ridge of the cutting blade is guided
parallel to the vehicle window.
The scraper knife is used for cutting back
bond remainders on the window flange or
the pane. Before re-bonding the vehicle
window, cut back the remaining bead to a
height of approx. 2 mm.
Fastening
element

Tool holder