Fein FSC1.6X Manual De Instrucciones página 19

3 41 01 120 21 0.book Seite 19 Dienstag, 10. März 2009 10:19 10
FSC1.6X/FSC1.6Q/FSC2.0Q
Attaching/replacing the sanding sheet (Figure 10).
Before mounting or replacing
WARNING
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the
power tool.
The sanding pad can be fastened on the
drive shaft at the suitable position. For wor-
king with the sanding pad, the adapter for
the FSC1.6X/FSC1.6Q/FSC2.0Q accesso-
ries (figure 9) are required.
Align the sanding sheet and press it
onto the sanding plate by hand.
Firmly press the power tool with the
sanding sheet against a flat surface and
briefly switch the power tool on. This
provides for good adhesion and pre-
vents premature wear.
The sanding sheet can be pulled off again
and then remounted offset by 120° when
only one tip of the sanding sheet is worn.
Fig. 10
Sanding
sheett
Sanding pad
en
19