To Charge The Battery Pack; To Charge The Battery Pack (Vehicle Charger P/N 10034276) - MSA Orion plus Manual De Operación

NOTE: Allow very cold battery packs to stabilize for 1/2-hour at room
temperature before attempting to charge.

To Charge the Battery Pack

• Align and connect the charger cable plug and battery pack
charging jack using the white alignment markers located on the
charger plug and the back of the battery pack or use the
charger cradle.
• Charger status is indicated by the LED color:
• Amber
The charge is pending; LED remains amber until the pack is
ready to be charged.
• Red
Charging is in process.
• Green
Charging is complete; the pack is fully charged and ready
for use.
• Red Flashing
Failure mode; remove battery pack from charger.
• LED OFF
No battery pack is connected.
To Charge the Battery Pack
(Vehicle Charger P/N 10034276)
• Connect the:
• input cable assembly to the automobile lighter and
• input to the charger assembly.
• Align and connect the charger cable plug and battery pack
charging jack by using the white alignment markers located on the
charger plug and the back of the battery pack.
• Charger status is indicated by the LED color:
• Yellow
Charge pending/Fault
• Solid Red
Charging is in process
• Solid Green
Charge complete.
4-2