WEG SSW 05 Plus Guia Del Usuario página 14

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Protection
Description
Available only when
Keypad HMI
HMI-SSW05-RS is used
Connection Fault
(see chapter 19)
Locked Rotor
Thyristor overload
(Internal Fault)
flashes 6 times
Overcurrent
(Overcurrent)
Incorrect phase
sequence
Undervoltage in the
(Internal Fault)
Control Supply
flashes 2 times
Internal
(Internal Fault)
By-pass relay
flashes 3 times
contact is open
Overcurrent before
(Internal Fault)
By-pass
flashes 4 times
Overcurrent of the
(Internal Fault)
SSW-05 By-pass
flashes 5 times
relay
Frequency out of
(Internal Fault)
tolerance
flashes 1 time
Note:
To prevent the E31 fault, when HMI-SSW05-RS is applied, please avoid resetting the fault through the digital inputs
(DI2) and through the reset key located on the SSW-05 front panel.
Fault Display
SSW-05
HMI-SSW05-RS
Front Panel
(see chapter 19.3)
LED
(Stall)
LED
LED
LED
(Phase Seq)
LED
LED
LED
LED
LED
English-14
Reset
E31
Power-on
This fault disa-
ppears automa-
tically when HMI
r e e s t a b l i s h e s
the communi-
cation with the
Soft-Starter.
E63
Power-on
Reset key
key
Auto-reset
DI2.
E64
key
Auto-reset
E66
Power-on
Reset key
key
Auto-reset
DI2.
E67
Power-on
Reset key
key
DI2.
E70
Power-on
Reset key
key
Auto-reset
DI2.
E71
Power-on
Reset key
key
Auto-reset
DI2.
E72
Power-on
Reset key
key
Auto-reset
DI2.
E73
Power-on
Reset key
key
Auto-reset
DI2.
E75
Power-on
Reset key
key
Auto-reset
DI2.
Possibles Causes
Keypad cable misconnected.
Electrical
noise
in
installation (electromagnetic
interference).
The time programmed for the
acceleration ramp is shorter than
the actual acceleration time.
Load on the motor shaft too high
Too much successive starts.
Short-circuit between phases.
Motor shaft is locked.
Network
phase
sequence
inverted at the input.
Electronics supply lower than the
required one.
SSW-05 is defective.
The time programmed for the
acceleration ramp is shorter than
the actual acceleration time.
Short-circuit between phases.
Motor shaft is locked.
The line frequency is out of ran-
ge (+/- 10%), when compared
with the rated frequency (50Hz
or 60Hz).
the

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ssw-05 plus serieSsw-05 plus 3aSsw-05 plus 10aSsw-05 plus 16aSsw-05 plus 23aSsw-05 plus 30a ... Mostrar todo

Tabla de contenido