WEG SSW 05 Plus Guia Del Usuario página 25

Parameter Description / Notes
P204
Load Factory Setting
P215
Keypad Copy Function
Note:
The Keypad Copy Function is only available when using HMI-SSW05-RS.
Figure 22.2 - Copying the parameters from the SSW A to the SSW B, by using the Copy Function
and the HMI-SSW05-RS keypad.
Programs all parameters to the standard factory default, when P204=5.
The parameters P000 and P295 are not changed when the factory default parameters
are loaded through P204=5.
The keypad copy function is used to transfer the content of the parameters from one
SSW to another.
P215 Action
0 Off
Copy
1
(SSW→ keypad)
Paste
2
(keypad → SSW)
Procedure is as follows:
1. Connect the keypad (HMI-SSW05-RS) to the SSW from which the parameters willl be
copied (SSW A - source SSW).
2. Set P215=1 (copy) to transfer the parameter values from the SSW A to the keypad.
Press key. During running of the Copy Function, display will show
P215 resets automatically to 0 (Off) after transfer has been completed.
3. Disconnect the keypad from the SSW (A).
4. Connect the same keypad to the SSW to which the parameters will be transferred
(SSW B - target SSW).
5. Set P215=2 (paste) to transfer the content of the of the keypad (EEPROM has the
SSW A parameters) to SSW B.
Press the key. While the keypad is running the paste function, the display shows
, an abbreviation for paste. When P215 returns to 0, the parameter
transfer has been concluded. Now SSWs A and B will have the same parameter
values.
To copy the parameter content of the SSW A to other SSW(s), repeat steps 4 to 5 above.
Soft-Starter
Parameters
HMI-SSW05-RS
English-25
Notes
Transfers the actual parameter values
of the SSW to non volatile memory
(EEPROM) of the HMI-SSW05-RS keypad.
The actual SSW parameters are not
changed.
Transfers the content of the non volatile
memory of the keypad (EEPROM) to the
SSW parameters.
Soft-Starter
A B
Parameters
SSW→HMI (Copy)
P215 = 1
Press
EEPROM EEPROM
HMI-SSW05-RS
-
HMI→SSW (Paste)
P215 = 2
Press
.