Operation Of The Digital Relay Outputs - WEG SSW 05 Plus Guia Del Usuario

13. OPERATION OF THE DIGITAL RELAY OUTPUTS:

The relay of the Operation Function closes its N.O. contact (13-14/23) always when the SSW-05 Plus receives the
enable command. This contact is open only at the end of the deceleration ramp (when it is set via trimpot) or when
the SSW-05 Plus receives the disable command.
The relay of the Full Voltage Function closes the N.O. contact (14/23-24) always when the SSW-05 Plus applies
100% voltage to the driven motor. This contact opens when the SSW-05 Plus receives the disable command.
t
t
t
English-10
Relay On