Restoring The Level Of The Rear Brake Fluid - Betamotor RR 400 Manual De Instrucciones

CHECK THE LEVEL OF THE REAR BRAKE
FLUID
Check the level of the brake fluid through
sight D. The level of the fluid should never
fall below the mark in the sight.
RESTORING THE LEVEL OF THE REAR
BRAKE FLUID
To restore the level of the brake fluid, un-
screw cap 3 and pour in brake fluid (IP
DOT 4) until the level reaches the mark in
sight D.
WARNING
We recommend using DOT 4 brake fluid.
Should this fluid be unavailable, use DOT
5.1 fluid instead. Do not on any account
use DOT 5 brake fluid. This is a purple
fluid with a base of silicone oil which re-
quires special seals and tubes.
WARNING
The brake fluid is extremely corrosive. Take
care not to spill it on the paintwork.
BLEEDING THE REAR BRAKE
Follow these steps to bleed the rear brake
circuit:
• Remove rubber cap E from valve F.
•Unscrew the brake fluid reservoir cap.
• Insert one end of a small tube into valve
F and place the other end in a container.
•Unscrew valve F (while pulling the lever)
and repeatedly operate the brake pedal
until the fluid comes out smoothly with no
air bubbles. During this operation, be sure
to never release the pedal completely and
keep pouring fresh fluid into the brake
pump reservoir so as to replace the fluid
that comes out.
• Tighten the valve and extract the tube.
• Replace the cap.
•Replace the screw cap on the brake
pump.
D
3
E
115
3
F
GB