Removing The Plastics - Betamotor RR 400 Manual De Instrucciones

3

REMOVING THE PLASTICS

To facilitate checks and operations in cer-
tain areas of the vehicle, it is essential to
remove the bodywork sections as de-
scribed below.
A
Removing the saddle
Remove the two fixing screws A (one on
each side), lift the saddle as shown in the
figure and pull it off from the back of the
vehicle.
Removing the rear mudguard
Remove the two fixing screws B and then
the two fixing screws C and D from under
the rear mudguard.
B
C
D
GB
125