Front Brake Lining Control; Rear Brake Lining Control; Check The Front And Rear Brake Pads - Betamotor RR 400 Manual De Instrucciones

3
GB

FRONT BRAKE LINING CONTROL

In order to verify the wear condition of front
brake is enough to view the plincer from
the bottom, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let's start replacing them.
Note
Perform the check according to the times
2
shown in the table on page 134.
WARNING
Failure to promptly replace the brake pads
can result in a considerable reduction of
the braking action and in damage to the
brake disc.

REAR BRAKE LINING CONTROL

Inorder to verify the wear condition of rear
brake is enough to view the plincer from
the back side, where is possible to glimpse
the brake lining tails which will have to
show a brake of 2 mm in thickness. If the
stratum is lesser let's start replacing them.
Note
Perform the check according to the times
2
shown in the table on page 134.
WARNING
Failure to promptly replace the brake pads
can result in a considerable reduction of
the braking action and in damage to the
brake disc.
116