Checking An Ip Address (Ip Scanner); Finding Duplicate Ip Addresses; Network Configuration Error - Bosch TTM 2104 Instrucciones De Servicio

8. Network configuration
i
TTM 2104/2204 works with static IP addresses. Networks
frequently work with dynamic IP addresses.
i
Dynamic IP addresses are assigned by the router/
server each time the system starts. Static IP
addresses are assigned once and then always remain
the same.
8.1

Finding duplicate IP addresses

1. Connect service PC/laptop to the network.
2. Disconnect TTM 2104/2204 from the network.
3. Open Entry prompt and enter
IP address" -t
.
 If a response is received, this IP address is al-
ready assigned in the network. Repeat item 3
with another IP address until there is no re-
sponse.
4. Note IP address for configuration.
i
Master and satellite each need a different IP
address.
8.3

Network configuration error

Description / message Possible cause
No network
R Satellite incorrectly configured
connection
between master
and satellite
Lights not illuminated
continuously
IP address unknown
R Format of IP addresses was not observed.
Invalid IP address
Robert Bosch GmbH
ping "planned
Leading zeros are not allowed. (10.10.33.06)
Network configuration | TTM 2104/2204 | 39
8.2

Checking an IP address (IP Scanner)

1. Connect service PC/laptop to the network.
2. Start the Advanced IP Scanner tool.
3. Select Scan button.
Fig. 12: Advanced IP Scanner tool
i
To simplify identification, all MAC addresses of
TTM 2104/2204 modules begin with 00061F.
Remedy / action
R Delete the master entry in the network
configuration of the satellite.
R Correct the satellite entry.
R Restart module.
R Set master entry (do not change satellite entry!).
R Restart TTM 2104/2204.
R Find with Advanced IP Scanner.
R Find by pinging.
R Reset IP address of module (see initial
commissioning of 1 691 206 002)
The MAC addresses of all modules begin with
00061F.
Observe format of IP addresses
10.10.33.6
en en
|
1 691 206 007 2017-06-19