Ryobi RAP200 Manual De Utilización página 11

GB
FR DE ES
SPECIFICATIONS
Flow Rate
Max working pressure
Container Size
Input
Weight
Paint Temperature
OPERATION
WARNING
Do not allow familiarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating products.
Failure to do so could result in objects being
thrown into your eyes, resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
ACCESSORIES
All accessories used with this product must be rated
greater than 20.7 Mpa (3000 psi). Ensure compatibility
and fit before using any accessory with this product.
APPLICATIONS
You may use this product for the purposes listed below:
„ Exterior painting and staining of decks, outdoor
furniture, fences, and interior/exterior rolling of walls.
WARNING
To reduce the risk of injection NEVER change
spray tip without locking the lock-out thumbscrew
on the sprayer and never point sprayer at
any part of the body, persons, or unit itself. In
case of skin injection, seek medical attention
immediately. Failure to heed this may cause
IT NL PT DK SE
1.09 L/min
19.3 Mpa (2800 PSI)
13.2 Liters
230 V 50 Hz, AC only,
670W, 3.1 Amp
14.06 Kg
5°C - 40°C
FI NO RU PL CZ
English
serious personal injury.
LOCKING THE PISTOL-GRIP SPRAYER
See Figure 8.
Always lock the pistol-grip sprayer trigger when you
have stopped spraying to prevent the sprayer from being
bumped or triggered accidentally and causing injection.
„ Turn lock-off thumbscrew counterclockwise to lock
sprayer trigger.
„ Turn lock-off thumbscrew clockwise to unlock sprayer
trigger.
RELEASE PRESSURE PROCEDURE
Always follow this procedure when shutting paint station
OFF for any reason. This procedure releases pressure in
the high pressure hose.
„ On pistol-grip sprayer, turn lock-off thumbscrew
counterclockwise to lock sprayer trigger.
„ Turn ON/OFF switch OFF.
„ Turn prime/spray lever to PRIME, as shown in figure
10. This releases pump pressure.
„ Unlock sprayer trigger and point to inside wall of paint
container releasing unused paint or stain back into
container. This releases pressure in the hose and
pistol-grip sprayer.
„ Turn lock-off thumbscrew counterclockwise to lock
sprayer trigger.
„ Leave prime/spray lever in the PRIME position until
ready to spray again.
FLUSHING THE PAINT STATION
Before using your new paint station or before beginning
a new project or changing colors, it is important to
thoroughly flush the paint station of any storage fluid,
previous cleaning fluid, or material left in the system.
Follow instructions for Cleaning the Paint Station before
beginning any project.
SET UP AND PRIMING
See Figure 9-11.
User must prime the pump and sprayer before beginning
any spraying or rolling.
„ Fill the 13.25 liter container with desired paint or stain.
Place lid on container.
NOTE: Paint container may also be removed and
replaced with larger paint container, 3.79 liter square
container or 3.79 liter container. Secure container
with elastic strap. Place lid on container.
„ Remove nozzle tip guard and spray tip from pistol-
grip sprayer.
„ Place intake tube in paint container.
5
HU RO LV LT EE HR SI SK GR TR