Troubleshooting - Ryobi RAP200 Manual De Utilización

GB
FR DE ES
OPERATION
CLEANING THE PISTOL-GRIP SPRAYER FILTER
See Figure 20.
„ Shut down the paint station using Release Pressure
Procedure.
„ Unplug the paint station.
„ Check that pistol-grip sprayer trigger is locked off.
„ Remove pistol-grip sprayer from the high pressure
hose using two adjustable wrenches.
„ Unscrew hex socket screw and lock nut to release
trigger guard from plate on the base of sprayer.
„ Using wrench, turn handle counterclockwise to
remove.
„ Remove filter from handle, noting direction of filter.
„ Thoroughly clean filter container with water (for water
based paints) or Cleaning Solvent/Paint Thinner (for
oil-based paints or varnish).
„ If filter has any holes, replace with new filter. NEVER
puncture filter with any object.
„ Replace filter in handle, tapered end down facing
back of sprayer. Sprayer will not work if filter is
improperly inserted in handle.
„ Reassemble pistol-grip sprayer in reverse order,
tighten securely.
MAINTENANCE
WARNING
When servicing, use only identical RYOBI
replacement parts. Use of any other parts may
create a hazard or cause product damage.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
PROBLEM
Paint station is not plugged in
On/Off switch in OFF position
Paint station has shut off while under
pressure
Motor does
not run No current coming from outlet
Extension cord is damaged or has low
voltage
A fuse has blown on paint station
Motor is not working properly
IT NL PT DK SE

TROUBLESHOOTING

CAUSE
FI NO RU PL CZ
English
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not at any time let brake fluids, gasoline,
petroleumbased products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
Do not abuse power tools. Abusive practices can damage
tool as well as workpiece.
WARNING
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
LONG-TERM STORAGE
See Figure 21.
When storing the paint station for 16 hours or more, a
thorough cleaning is recommended.
„ Shutdown paint station.
„ Thoroughly clean paint station and sprayer according
to instructions.
„ Be sure that machine and tubes are clear any water
or fluid as these may freeze.
„ Coil 7.62 m. high pressure hose and store on back of
tool with hook and loop straps.
„ Keep intake tube and prime tube in 13.25 liter paint
container. Store filter and sprayer in plastic bag and
seal.
„ Fold handle over front of tool.
Make sure unit is plugged in
Turn On/Off switch to ON
Turn the high/low pressure knob to maximum pressure or release
pressure by turning Prime/Spray lever to Prime
Test the power supply voltage
Replace extension cord
Contact Authorized Service center
Contact Authorized Service Center
9
HU RO LV LT EE
POSSIBLE SOLUTION
HR SI SK GR TR