Setting The Time; Hiding And Un-Hiding The Clock - Pando PHC-943 Manual De Uso

INOXPAN S.L.

1.6. SETTING THE TIME

 When you plug the oven, you will see the clock flashing 12:00.
 Press or to adjust the hours.
 Press to confirm the hours.
 Press or to adjust the minutes.
 Press to confirm the minutes.
 If you wish to modify the time, press
the instructions in the previous points.
n the event of power failure, the clock settings will be erased and 12:00 will flash on the clock
display. Reset it and program again.
1.7.

HIDING AND UN-HIDING THE CLOCK

 If you wish to hide the clock press
 If you wish to see the clock on the display again, press
PROGRAMING THE BUZZER
1. Touch or until the
"0_00" will appear on the display.
2. Select the time after which you want the alarm to sound by pressing
beeps to confirm that the time has been set and the clock will start counting down from the
selected time. The
Warning: This action must be done in no more than 5 seconds.
3. Once the time has expired, an acoustic signal will sound 3 beeps spaced at 30-second intervals
will sound 90 seconds and the
With the Buzzer function, the oven will not turn off when the time expires.
4. Touch any key to stop the alarm. The
If you wish to modify the time on the buzzer, press
not flashing; then press
currently remaining will appear which you will be able to adjust
With the Buzzer function, the remaining time will show permanently on the display. With this
programmed function, it is not possible to view the time or the total programmed cooking time.
When the oven is turned off, the internal fan can continue to run for a few minutes. This is
or
for 5 seconds.
symbol on the display starts flashing, then press
symbol will flash slowly.
symbol will flash quickly.
symbol will then disappear.
and repeat the steps shown. Upon entering the timer control, the time
until the time starts flashing. Press
for 5 seconds.
or until the
EN - 8
and follow
The indication
or . You will hear 2
flash and the hours are
normal.