Take (Taking A Call) - Aastra 400 Serie Manual Del Sistema

Prestaciones
9. 6. 24

Take (taking a call)

The Take function allows users to take over a call connection of another user
without interrupting the connection or having the connection put through to
them. The example below illustrates how to accept a call connection from a user
with a cordless phone.
Fig. 226 Take (taking a call)
User A has set up a call connection with user B, who transfers the call to user C's cor-
dless phone by pressing a key. Caller A is not aware that the call has been transfe-
rred.
Detailed Description
Tab. 295 Take (taking a call)
Interface
C
System configuration
Tab. 296 Take: Key configuration
Function type
In AMS or on the cordless phone the
following command is used to pre-
pare a configurable key to allow user
C to take over user B's call:
I *87 B * C # X I *88 #
Tip:
Take is actually nothing other than the preparation for accepting a call
and accepting the call from the same terminal. This function can be
carried out more simply using the Fast Take feature.
488
A
haz0941aaxxa0
Operating sequence / signalling on the terminal
Activating via the configurable key on the cordless phone
Note
Requirement:
The Prepare call acceptance
Restriction:
Only simple connections can be accepted, not conferences, users on
hold, etc.
B
C
authorization must be enabled with user C.
Funciones y prestaciones del sistema a partir de R2.1
syd-0370/1.2 – R2.1 – 07.2012