Warranty - Brill 40 BHR Manual De Instrucciones

Powered equipment can cause
serious injuries! You are respon-
sible for safety in the area where
you are working. Never start the
equipment whilst tilted – risk of
injury!
Always use the equipment solely
for the purpose described in the
operating instructions.
Never permit the combustion
engine to run in enclosed spaces
where dangerous exhaust gases
can collect.
Only use this unit in daylight or
when the area where you are
working is lit by ample artificial
lighting.
Make sure that the air vents are
free of dirt.
Ensure that you are standing
safely and on firm ground, even
on a slope.
Work across the slope, never up
and down.
Do not work on excessively
steep slopes.
Be careful if you change direc-
tion on a slope, turn the machine
round or draw it towards you.
Be careful if you are going back-
wards, risk of stumbling!
Only push the equipment at
walking pace.
Turn the motor off if the equip-
ment has to be tilted when trans-

Warranty

The manufacturer warrants its
products for exclusively non-
commercial use for a period of
24 months from the date of orig-
inal purchase. This warranty does
not affect statutory warranty
porting it over surfaces other than
grass and if you are transporting
the equipment backwards and
forwards to the work area.
Never use the machine with
damaged protective devices or
without protective devices.
Never change the basic settings
of the machine or rev the engine
too hard.
Disconnect all the cutting tools
and drives before you start the
motor.
When starting or operating the
starter switch take care as stipu-
lated by the manufacturer's
instructions. Ensure that your feet
are far enough away from the
cutting tool.
When starting or switching on the
motor, the machine should not
be tilted unless the machine has
to be raised during the process.
In this case only tilt it as far as
absolutely necessary and only
raise the side away from you.
Do not start the motor when
you are standing in front of the
discharge duct.
Keep your fingers and feet away
from the cutting tool!
Keep your hands and feet away
from the interior housing and
discharge when the motor is run-
ning.
Never lift or carry a machine
with the motor running.
claims. The warranty covers all
substantial faults of the product,
which are caused by defects in
material and workmanship. If
a product exhibits such a defect
we will, at our option, repair or
Stop the cutting tool if it should
be necessary to tilt the appliance
or if it is transported across sur-
faces other than grass, and
when moving the appliance from
and to the surfaces which are to
be worked on.
Each time you have to work on
the machine or leave it or top it
up, always switch off the motor.
If you strike an obstacle when
working, please disable the
machine. Remove the spark plug.
Remove the obstacle, check the
equipment for any damage and
have it repaired if necessary.
If the equipment begins to
vibrate strongly, remove the spark
plug and ascertain the cause.
A
Taking a Break
Never leave the equipment unat-
tended. If you stop work, switch
the machine off and remove the
spark plug.
If you stop work to go to a dif-
ferent work area, it is essential
to turn the equipment off and
remove the spark plug.
Beware of Environmental
A
Influences
Comply with local quiet periods
in your community!
As a user of the appliance, you
are responsible for Third parties
in your range of action.
replace it without cost for parts
and labour provided the follow-
ing requirements are fulfilled:
The product must have been
.
sold to the customer in
a legally correct way.
GB
25