Warranty - Brill 42 BFR Manual Del Usuario

Do not start the motor when you
are standing in front of the dis-
charge duct.
GB
Keep your fingers and feet away
from the cutting tool!
Keep your hands and feet away
from the interior housing and
discharge when the motor is run-
ning.
Never lift or carry a machine
with the motor running.
Each time you have to work
on the machine or leave it or

Warranty

The manufacturer warrants its
products for exclusively non-com-
mercial use for a period of
24 months from the date of
original purchase. This warranty
does not affect statutory war-
ranty claims. The warranty
covers all substantial faults of the
product, which are caused by
defects in material and work-
manship. If a product exhibits
such a defect we will, at our
option, repair or replace it with-
out cost for parts and labour
provided the following require-
ments are fulfilled:
The product must have been
.
sold to the customer in a
legally correct way.
The original receipt with the
.
customer's address, date of
purchase, model and product
designation is presented as
proof of purchase. The product
must have been purchased
within the EC.
The product was handled
.
properly and according to the
recommendations in the oper-
26
top it up, always switch off
the motor.
If you strike an obstacle when
working, please disable the
machine. Remove the spark plug.
Remove the obstacle, check the
equipment for any damage and
have it repaired if necessary.
If the equipment begins to vibrate
strongly, remove the spark plug
and ascertain the cause.
ating instructions. It is essential
that the product has been
maintained and cleaned
according to the information in
the operating instructions. No
attempt to disassemble or
repair the product has been
made by either the buyer or
an unauthorised third party.
It must be ensured that only
.
original replacement parts and
original accessories approved
by the manufacturer are used.
There may be an increased
risk of consequential damage
and accidents if non-original
parts or non-original acces-
sories are used. This warranty
does not cover consequential
damages.
The product must be either
.
taken directly or sent with
postage paid to an authorised
service centre. The original
receipt must be sent with the
product.
The warranty does not cover
.
damage from misuse, abuse,
use of unsuitable, non-original
A
Taking a Break
Never leave the equipment unat-
tended. If you stop work, switch
the machine off and remove the
spark plug.
If you stop work to go to a dif-
ferent work area, it is essential
to turn the equipment off and
remove the spark plug.
Beware of Environmental
A
Influences
Comply with local quiet periods
in your community!
or unauthorised interchange-
able parts, replacement parts
or accessories, as well as
improper maintenance and
cleaning.
The products contain various
components that are subject to
normal or use-related wear.
The warranty does not extend to
these wearing parts.
In particular the following com-
ponents relating to this product
are excluded:
Blades / blade bar / drive belt /
care roller / blade roller /
lower blade / cutting plate /
cutting line / cutting head cover /
saw blade / nickel /
cadmium-cell (battery) / brush /
aerator cylinder.
The manufacturer warranty does
not affect existing warranty
claims between the customer
and the dealer / seller.