Cleaning And Disinfecting - FujiFilm Sonosite S II Stand Manual Del Usuario

Cleaning and disinfecting

To avoid electrical shock, before cleaning, always disconnect the system from
To avoid injury, always use protective eyewear and gloves when performing
To avoid infection, ensure that the solution expiration date has not passed.
WARNINGS:
To avoid infection, the level of disinfection required for a product is dictated by
Use only recommended cleaners or disinfectants on surfaces. Immersion-type
Caution:
disinfectants are not tested for use on surfaces.
To clean and disinfect the stand
You can clean and disinfect the exterior surface of the stand using a recommended cleaner or disinfectant. For
the most recent list of approved products, see www.sonosite.com.
1 Turn off the ultrasound system and any accessory equipment. Disconnect the system and accessory
equipment from AC power.
2 Clean the stand surfaces to remove any debris or bodily fluids. Use the following procedure:
a Use either a pre-moistened wipe or a soft cloth dampened with cleaner or disinfectant.
Approved cleaners and disinfectants for the stand
Cleaner/disinfectant
SaniCloth AF3 (gray top)
SaniCloth Plus (red top)
PI-Spray II
1 For maximum effectiveness, the component being cleaned must remain wet with disinfectant for a
minimum period of time.
2 Qualified for use as an intermediate-level disinfectant for mycobacteria. For a more complete list, refer to
the cleaners and disinfection document available at
b Remove all gel, debris, and bodily fluids from the stand.
SonoSite SII Stand User Guide
the power supply.
cleaning and disinfecting procedures.
the type of tissue it comes into contact with during use. Ensure that the
solution strength and contact time are appropriate for the equipment. For
information, see the disinfectant label instructions and the recommendations
of the Association for Professionals in Infection Control and Epidemiology
(APIC) and FDA.
2
Minimum wet contact time
3 minutes
3 minutes
20 minutes
www.sonosite.com
1
11