Cleaning And Disinfecting - FujiFilm SonoSite X-Porte Manual Para El Usuario

Gynecological calculations
Measuring follicles
You may choose to make one, two, or three-dimensional follicular measurements and volumes. Each
individual follicle you measure will have its own follicle number, and you can measure up to 10
follicles. In addition, each follicle can have up to three measurements. All of the follicle measurements
are represented in the final report.
To measure follicles
Save Set
The button is no longer needed and has been removed. Use the revised procedure below:
1 On the frozen 2D image, tap
Calcs
If this control is hidden, tapping
2 On the Follicle Right
calculation list, do the following for each measurement you want to take:
If the calculation list is not visible, tap
a Tap the follicle number. If this is the first follicle you are measuring, tap 1.
b Position the calipers by dragging.
c To measure a second dimension of the same follicle, tap
measurement, tap
A superscripted measurement number appears after the follicle number to indicate the
dimension being measured.
d Position the calipers by dragging.
e Tap
f To measure a third dimension of the same follicle, acquire a new image of the follicle, and then
tap the same follicle number.
A superscripted measurement number appears after the follicle number to indicate the
dimension being measured.
g Position the calipers by dragging.
h To save the third measurement, tap

Cleaning and disinfecting

The list of cleaners and disinfectants approved for use with the X-Porte ultrasound system,
transducers, and accessories has changed.
26
Calcs .
More Controls
(if measuring the right side) or
under the follicle number.
under the follicle number to save the first two measurements.
displays it.
Follicle Left (if measuring the left side)
at the top of the current list.
Next, or to save just the first
under the follicle number.