Adjustment Of The Open Tray Dispensers; Adjust The Model Ota/S - Hupfer OTA/47-36 Manual De Instrucciones

Operation

Adjustment of the open Tray Dispensers

5.2 Adjustment of the open Tray Dispensers
5.2.1

Adjust the model OTA/S

INFO
Figure 10
Adjust the sideways tray guide rails
The holders of both tray guiding rails have to be fixed with two cap nuts on the left and right sides on the
spring case. The sideways tray guide rails are adjusted correctly when after the adjustment the trays are lo-
cated centrally on the stacking platform and sideways have a distance of 0.19'' (5 mm) to the tray guide rails.
To adjust the sideways tray guide rail, proceed as follows:
§
Loosen all four cap nuts, but do not unscrew them completely.
§
Bring the two tray guiding rails evenly in the right position and align them vertically.
§
Screw the four cap nuts of the tray guiding rails tight.
4330041_A2 OTA/47–36 | OTA/53–37 | OTA/58-33 | OTA/53–37 S | OTA/U-BW | OTA-E/BA-4xGN | TAG-1/53-37 | TA-2/53-37 | EBS-T/53-37
Required tools
You need the following tools for the adjustment:
Open-end wrench SW 17,
Philipps screwdriver size 1,
Screwdriver size 7 (chisel width 6-7 mm) and thickness 0.8–1 mm)
Adjust tray guide rails
Chapter 5
Page 23
Tray dispenser