Ki Mobility Little Wave Clik XP Manual De Instrucciones Y Garantía página 30

V. SET UP & USE OF YOUR WHEELCHAIR
M. Replacing the Camber Tube (Continued)
3. Center camber tube in camber clamps.
4. Insert camber adapter into end of camber tube. If using 2°, 4° or 6° camber adapters, rotate
thin wall of threaded end until it is pointing up and through holes align with through holes in
camber tube.
5. Press threaded barrel (Fig. 17:E) into through holes in camber tube.
6. Insert 6mm screw (Fig. 17:D) using two Allen wrenches into threaded barrel and tighten.
7. Repeat steps 3 thru 5 on opposite side of chair.
8. Put rear wheels back onto chair. Refer to Setting Toe to Zero in Section K to ensure wheels are
properly set up and to finish installation of camber tube.
C
E
D
Fig. 17
A
B
28