Scope Of Delivery; Accessories - salmson SIL Serie Instalacion Y Puesta En Servicio

Ocultar thumbs Ver también para SIL Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

English
Property
Approved fluids
Electrical connection
Special voltage/frequency
PTC thermistor sensor
Speed control, pole switchover
Explosion protection (EEx e, EEx de)
Table 1: Technical data
Fluids
5.3

Scope of delivery

5.4

Accessories

36
Value
Heating water according to VDI 2035
Process water
Cooling/cold water
Water/glycol mixture up to 40 Vol.-%
Heat transfer oil
Other fluids (on request)
3~ 400 V, 50 Hz
3~ 230 V, 50 Hz
(up to 3 kW inclusive)
3~ 230 V, 50 Hz
(from 4 kW)
3~ 380 V, 60 Hz
Pumps with motors with different
voltages or with other frequencies
are available on request.
standard version from 75 kW
Salmson control devices
(e.g. Salmson-CC/SC-HVAC-System)
Pole switchover
up to 37 kW
If water-glycol mixtures are used (or fluids with a viscosity other than
that of pure water), an increase in power consumption of the pump is
to be taken into account. Only use mixtures with corrosion protection
inhibitors. Observe the relevant manufacturer specifications.
• Adjust the motor power if required.
• The fluid must be sediment-free.
• Salmson's approval must be obtained for the use of other fluids.
• In systems built according to the state of the art, it can be assumed
under normal system conditions that the standard seal/standard
mechanical seal is compatible with the fluid. Special circumstances
(e.g. solid material, oils or EPDM-corrosive substances in the fluid, air
in the system etc.) may require special seals.
NOTE:
Always read and follow the material safety data sheet for the fluid
being pumped!
• Pump SIL/DIL/PBS
• Installation and operating instructions
Accessories must be ordered separately:
• PTC thermistor tripping unit for switch cabinet installation
• SIL/DIL: 3 mounting brackets with fixation material for installation
on a base
• DIL: Blind flange for repair work
• PBS: For installation on a base or baseplate for rated power of 5.5 kW
and above
For a detailed list, consult the catalogue and spare parts
documentation.
Remarks
Standard version
Standard version
Standard version
Standard version
Special version or auxiliary equip-
ment (at additional charge)
Special version or auxiliary equip-
ment (at additional charge)
Standard version
Alternative application for stand-
ard version (no additional charge)
Special version or auxiliary equip-
ment (at additional charge)
partially standard version
Special version or auxiliary equip-
ment (at additional charge)
Standard version
Special version or auxiliary equip-
ment (at additional charge)
Special version or auxiliary equip-
ment (at additional charge)
Salmson 11/2017

Publicidad

Tabla de contenido
loading

Tabla de contenido