Tabla de contenido
Publicidad
Continuation of figure 2.36:
Press:
To switch to engine speed regulator coarse adjustment mode. (Parameter 4P)
To increase or reduce the engine speed by large intervals.
or
To switch to engine speed regulator fine adjustment mode. (Parameter 4P)
To increase or reduce the engine speed by small intervals.
or
To switch to engine speed regulatory stability (gain) coarse adjustment.
(Parameter 5P)
To increase or reduce the engine speed regulator stability (gain) by large
intervals.
or
To switch to engine speed regulatory stability (gain) fine adjustment.
(Parameter 5P)
To increase or reduce the engine speed regulator stability (gain) by small
intervals.
or
To switch to "SAVE" mode. See figure 2.38.
Note: Ensure that the selections made have been saved before exiting configuration mode. The controller restores the
selections most recently saved when the main switch is set to "OFF/RESET".
* The grey boxes indicate the character displayed on the controller screen relating to the adjustment selected. X in the examples
above denotes any figure between 0 and 9. The actual values may vary according to the generating set model.
There are three options when the screen displays "SAVE":
Press:
To return to the first setting (voltage coarse adjustment) in order to check that
the modification has been taken into account before saving. See figure 2.36.
or
To save the changes.
or
To cancel the changes, without saving..
The words "Yes" or "no" flash on screen when the up or down arrow is pressed and then the
controller exits configuration mode. The screen then displays the hours of operation once more.
The main switch should now be set to "OFF/RESET".
Figure 2.37: Output frequency and voltage adjustments, continued
Figure 2.38: Save mode
39/73
Display:*
4
P
X
X
4
P
X
X
5
P
X
X
5
P
X
X
S
A
V
E
S
A
V
E
1
P
X
X
Y
E
S
n
o
X
X
X
X
Publicidad
Capítulos
Tabla de contenido
