SDMO RES 9.5EC Manual De Instalación, Uso Y Mantenimiento página 98

Fuel conversion procedure
1. Lift the generating set bonnet.
2. Unscrew the two retaining screws of the side panel.
3. Remove the side panel of the enclosure.
4. Move the main switch on the generating set to "OFF".
5. Isolate the battery charger from its electrical power supply.
6. Disconnect the generating set engine starter battery, negative (-) lead first.
7. Close off the fuel supply.
8. Loosen the clamp then disconnect the flexible hose from the union.
1
1. Screws
22/73