IBM Aptiva Guía De Consulta página 41

Garantías y avisos
and safety requirements. The Department does not
guarantee the equipment will operate to the user's
satisfaction.
Before installing this equipment, users should ensure
that it is permissible to be connected to the facilities of
the local telecommunications company. The equipment
must also be installed using an acceptable method of
connection. In some cases, the company's inside wiring
associated with a single line individual service may be
extended by means of a certified connector assembly
(telephone extension cord). The customer should be
aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an
authorized Canadian maintenance facility designated by
the supplier. Any repairs or alterations made by the user
to this equipment, or equipment malfunctions, may give
the telecommunications company cause to request the
user to disconnect the equipment.
Users should ensure for their own protection that the
electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system,
if present, are connected together. This precaution may
be particularly important in rural areas.
¡Precaución!
Caution! Users should not attempt to make such
connections themselves, but should contact the
appropriate electric inspection authority, or electrician,
as appropriate.
Notice: The LOAD NUMBER (LN) assigned to each
terminal device denotes the percentage of the total load
to be connected to a telephone loop which is used by
the device, to prevent overloading. The termination on a
loop may consist of any combination of devices subject
only to the requirement that the sum of the LOAD
NUMBERS of all the devices does not exceed 100.
37
Avisos